Designed to allow the replacement of the worn driveshaft boot without dismantling any mechanical part.

Made of a special ultra-resistant rubber and equipped with an innovative opening system and special channel for the glue.

Thanks to its elasticity and design, it adapts to most CV joints and half shafts of car manufacturers.

Due to the particularity of the glue that welds the two parts in less than 30 seconds, be careful to carry out the simple jointing operation in a short time and in a comfortable position.

Easy boot is suitable for most axle shafts up to a diameter of approximately 29 mm, for axle shafts with a larger diameter (very rare on cars) the boot may not close and become unusable

Never use an adhesive other than the one supplied in the kit, Hippored in this case does not guarantee the correct functioning of the product